so I have power at the fuse orange wire, under the dash and no power to K10 -514- and no power at K6 -694- so can anyone tell me is it the turn signal switch ? thanks Paul.
Paul,
Yes, the turn signal switch provides the power to those two circuits when the hazard switch is OFF and the ignition switch is ON.
You can bypass the K10 relay to test out your rear taillights as I have pointed out to you before.
Also if you do change the turn signal switch, make sure to read the following posts
http://www.mercurycougar.net/forums/showthread.php?60594-Help.-Brake-lights-are-melting-turn-signal-switch.&highlight=turn+signal+switch , see Buddy 97’s post #12 inspecting and modifying turn signal switch’s electrical connections before installing
http://www.mercurycougar.net/forums/showthread.php?72890-Turn-signal-fuse-location/page3 , see CatMan’s post #33 inspecting and modifying turn signal switch’s plastic “gateways” before installing
Coach Jack
Coach Jack, thanks for your patience as I learn about this system I’m also learning how to do these procedures with a ohm meter going from the schematic to the meter to utube for a video on how to use the ohm meter. Thanks Paul. I did put power to K10 and the dash indacators are both lit and I get the rear out side blinking with intermittent middle blinking with no out side blinking, hazards are working front and back, slowly, and the headlights work front and back also brake lights are working. I will finish posting in the sticky thread. Thanks Paul.